odie
TOTW Team
- Joined
- Dec 22, 2006
- Messages
- 7,227
- Likes
- 10,989
It's been years since I was aware of one of these available, but I'd like to experiment with a scraper made from 1/2" half round stock. If I remember right, the reason I once rejected the idea, was it would be difficult to grind, seeing as how the round side would be facing down on the platform.
Well......I've now come to the point where I'd like to experiment with one of these half round scrapers, but don't know where it might be available, if there still is such a critter.
I think if one got creative, a special jig could be made that would keep the cutting edge parallel to the Wolverine platform, and overcome the problems I once perceived.
Anyone know where I can get one of these?
Thanks
-----odie-----
edit: I'm also interested in finding a "quick change" lathe tool handle that is specifically geared to holding 1/2" x 1/2" square stock. (ie: 1/2" x 12" HSS metal lathe cutter bit ....thx)
.
Well......I've now come to the point where I'd like to experiment with one of these half round scrapers, but don't know where it might be available, if there still is such a critter.
I think if one got creative, a special jig could be made that would keep the cutting edge parallel to the Wolverine platform, and overcome the problems I once perceived.
Anyone know where I can get one of these?
Thanks
-----odie-----
edit: I'm also interested in finding a "quick change" lathe tool handle that is specifically geared to holding 1/2" x 1/2" square stock. (ie: 1/2" x 12" HSS metal lathe cutter bit ....thx)
.