Video on Turning a Half-Twist Bowl

[brian horais]

I've posted a number of images of my half-twist bowls on the photo gallery. The process I use to make these is a combination of on-center and off-center (multi-axis) techniques. Recently I've gotten some comments suggesting I make a video on how to turn these shapes. Here's a link to my recently created YouTube video:

View: https://youtu.be/j4r3_oqpm1k


Enjoy!

Brian Horais
Knoxville, Tennessee
2019 AAW Raleigh demonstrator

 

[Damon McLaughlin]

Brian,

I really enjoyed watching your video on how to make the twisted vessels. One comment I have is at the 2:45 point in the video you mention using a bowl gouge to start the shaping. To me it looked more like a roughing gouge than a bowl gouge. If it was in fact a roughing gouge is that a safe cut for it?

 

[Don Bomer]

Brian, this is certainly an amazing technique and I very much appreciate you sharing your knowledge. Absolutely beautiful!

 

[brian horais]

Damon, Yes I did mean to say roughing gouge. I think I had bowl gouge on my mind as an alternative for the 'edge cuts' where I used my Hunter Hercules 3 tool. The roughing gouge takes too wide a bite when trying to cut a precise edge.

 

[brian horais]

Thanks Don! I really enjoy making these 'non round' shapes on the lathe. Be sure to take a look at the tutorial on my website (www.horais.com/links) for more information on how the three point off-axis turning is done.

 

[Bryan Lisowski]

Brian, that was a really well done demo! Thanks for taking the time to video it.