Looking for a quality used drill chuck with a #2 Morse Taper
If you think you should have bought a keyed chuck instead then that could well be the reason for spending more money on a chuck! I used and hated a cheap keyed chuck (PITA to use, made divots in my drill shanks), tried and discarded a cheap keyless chuck (didn't hold very well, made divots in my drill shanks), found the Albrechts and now have nothing to complain about. Between the ease of use and not having to go searching for the ever-missing chuck key I'm never going back! Spending $500+ on a new one would be a non-starter, but the used ones I've found seem to be just fine for my needs.Is there a reason for spending that kind of money on a drill chuck for the lathe? I paid about $65 for a keyless chuck new and it's never failed me. Works well. Just wondering what I'm missing. I would say that, after using it awhile, I decided that I should have bought a keyed chuck instead.
Sent PM, I have a few extras of these.
That's a really nice upgrade. I assume it made many tasks easier. I like the chucks not only for their drilling to start hollow forms, but also for their flexibility in attaching tools/accessories/etc. to the lathe.Really the only thing I don't like about my keyless chuck is that it is a little difficult to tighten down. This problem has been mostly eliminated since I upgraded my lathe from a Nova Comet II to the Powermatic 3520C. I think my original difficulties were due to a cheap tailstock which didn't easily move in and out no matter what I did to clean it and lubricate it. The Powermatic tailstock moves smoothly and I rarely have problems with tightening chuck on the bit. Never had any divots in my bit shafts.
Anyway, I really don't use it very much except for pens (which I rarely turn) and sometimes for hollowing as a preliminary step (although I can sometimes get most of the inside hollowed just as easy with my hollowing tools).