If anyone has a slow speed sharpening system w/ sharpening jigs pls let me know. I have been sharpening by hand for quite some time now and would like to purchase a used system until I can afford to purchase new. Thanks
Here’s a cost effective solution until you get what you really want. Cut out a 12“ circle of particle board and mount it to a faceplate (or glue on a small block to attach to chuck. Then get a 12” round self sticking sandpaper (80 or 120 grit) from the hardware store to create a sanding disk for sharpening tools.If anyone has a slow speed sharpening system w/ sharpening jigs pls let me know. I have been sharpening by hand for quite some time now and would like to purchase a used system until I can afford to purchase new. Thanks
Agree, I have the Rikon and Vari-grind setup myself. A sanding disc was something that a recent demonstrator said he carried with his tools just in case there is no grinder at the teaching location. Still I think having an inexpensive disc sander around is handy for other things besides sharpening tools. Just need to keep an eye out for an extra faceplate which can always be repurposed if/when needed.That may be cost effective but not much else. The little Rikon 1/2 HP grinder comes on sale for $99, you can buy a Vari-grind jig for $53 - a base for $33 and a V arm for $21. Slightly over $200 you have a brand new sharpening system. Throw in another base and you can use both stones. The system gives you repeatability to your sharpening not to mention that if your tool needs sharpening that you would have to take the piece and off put on your sandpaper board to sharpen. And if you need cheaper get a Harbor freight grinder and make the system cost less, a high speed grinder just requires less pressure.