Over Christmas I was gifted a large spalted maple round bowl blank. It's 6.25" thick and 13" in diameter. I'd like to cut it into two blanks so that I can make two shallow bowls. But It's too big to fit under my bandsaw so my only other option is my chainsaw which seems a bit brutal for the task.
I suppose I could fabricate a jig to hold it on my table saw and cut it partway through and then hand saw the rest.
Any other options?
I suppose I could fabricate a jig to hold it on my table saw and cut it partway through and then hand saw the rest.
Any other options?