The bolt which locks the toolpost in the harp snapped off on my 3520. I had extended the lever with a 6" wooden turned handle and it worked fine for the last 450 bowls/vases. The original lever at 3" just was too difficult to properly tighten.
Of course the toolpost was locked into the harp as well. So after a few choice words I spent the next 2 hours drilling it out and retapping the hole. Now I have a temporary bolt in there which is tightened by a crescent wrench. Has anyone else had this happen, and if so what did you do to fix it longterm?
Of course the toolpost was locked into the harp as well. So after a few choice words I spent the next 2 hours drilling it out and retapping the hole. Now I have a temporary bolt in there which is tightened by a crescent wrench. Has anyone else had this happen, and if so what did you do to fix it longterm?