. I haven't seen it. It's a Craigslist ad about an hour and a half away. We may be buying a place with a 24'x36' shop soon so I think I'll wait and get a modern VFD controlled lathe.Isn't there any type of data plate with electrical, etc.??
. I have thought of that but for a 14" lathe I doubt it would be worth my time.We have 2 in our high school shop set up. They work fine, except it's got the Reeves drive. The lowest speed is not very low, you can only change speed with the lathe running, and the availability of a replacement sheave, when eventually one goes bad, is unlikely. If you're handy and could retrofit it with a VFD when the time comes, they are otherwise satisfactory, IMHO.