I have a brand new Jet 1221 Step Pulley lathe.
Runs great.
One thing is that after 20-30 minutes the motor gets real hot. After 40 minutes it is too hot too keep my hand on it.
There is no air path through the motor as it would just fill up with chips but there is a fan on it.
is this normal ??
Thanks in advance for your replies.
Runs great.
One thing is that after 20-30 minutes the motor gets real hot. After 40 minutes it is too hot too keep my hand on it.
There is no air path through the motor as it would just fill up with chips but there is a fan on it.
is this normal ??
Thanks in advance for your replies.