Where can I find a jaycobs chuck that accepts a drawbar mt2 that is less than $100
-
Beware of Counterfeit Woodturning Tools (click here for details) -
Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details) -
Congratulations to Peter Jacobson for "Red Winged Burl Bowl" being selected as Turning of the Week for April 29, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Jacobs chuck
- Thread starter Tom Gibbons
- Start date
Several choices here. Been using one for years.
Penn State Industries: Product Search
www.pennstateind.com
Thanks will look them up
I'm curious, why with a draw bar? I've never had a worry of mine falling out.
Primarily for using the chuck in the headstock (I do at times for various reasons) and a drawbar can be used in the TS - sometimes a deep drill bit can pull the chuck out when retracting. You can hold it by hand or use a drawbar.
Drawbars are good but I've had to remove things that were installed with the overenthusiastic use of one. If the chuck, collet,etc, can't be removed with a drift or by backing off the drawbar, be careful how far you tighten it. I hate pounding on bearings.
True. I use a small knob, 1-1/2” dia to tighten the drawbar for this reason. It does not need to he-manned, simply snugged up - the all thread is not going to stretch. Its there only to prevent the taper from coming out.