I recently acquired the Sorby narrow parting tool but have no idea how to sharpen.
Tony
Tony
-
Congratulations to Kelly Shaw winner of the March 2025 Turning Challenge (click here for details) -
Congratulations to Steve Bonny for "Rhonda and Fisherman"being selected as Turning of the Week for March 31st, 202 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
How to sharpen narrow parting tool
- Thread starter Tony Dentino
- Start date
- Joined
- May 16, 2005
- Messages
- 3,540
- Likes
- 20
Tony Dentino said:
Mine came with instructions in the sleeve, but basically the flat, rather than the notched face is touched up with a stone.
Sharpen it Only on the non-flutted surface. I don't use a grinder to sharpen mine; I use a 180 grit, diamond, flat, "stone." Make sure you maintain the proper angle and that the surface is flat, i.e., not heel down or tip down. It takes only about 4 passes unless you dropped it tip down.