John Van Domelen
Retired Forum Admin
Home-made Foredom Stand
I was wanting to take a pic of the stand I built, but the studio has been a mess of late. I 'lost' one of my new Typhoon bits right in the middle of working on a piece. I figured that I blew it on the floor with compressed air. Anyway, after much vacuuming, and checking the waste cans with a big magnet, I of course found the cutter in the back of the bit box... but the studio got cleaned, so I snapped a pic of the hanger.
I did not like the commercial units - too flimsy. I made this one from Home Depot pipe.
shopping list (all 1/2 pipe fittings:
1 floor flange
2 12 inch lengths pipe
2 5 inch length pipe
1 T fitting
1 coupler fitting
2 end caps
Parts were under 20 bucks and it will last forever.
I was wanting to take a pic of the stand I built, but the studio has been a mess of late. I 'lost' one of my new Typhoon bits right in the middle of working on a piece. I figured that I blew it on the floor with compressed air. Anyway, after much vacuuming, and checking the waste cans with a big magnet, I of course found the cutter in the back of the bit box... but the studio got cleaned, so I snapped a pic of the hanger.
I did not like the commercial units - too flimsy. I made this one from Home Depot pipe.
shopping list (all 1/2 pipe fittings:
1 floor flange
2 12 inch lengths pipe
2 5 inch length pipe
1 T fitting
1 coupler fitting
2 end caps
Parts were under 20 bucks and it will last forever.