Has anyone run into problems with tightening a tool rest on the Delta Midi Lathe?
I noticed that the threaded portion on this handle is a bit too short and doesn't allow for tightening down the tool rest, resulting in occasional movement. The problem is amplified when a heavier rest (12") is used
Further, has anyone come up with a better and more reliable way for tightening down the rest in place so it doesn't move? If so, I would love to hear what your doing.
Thanks for any help in advance.
I noticed that the threaded portion on this handle is a bit too short and doesn't allow for tightening down the tool rest, resulting in occasional movement. The problem is amplified when a heavier rest (12") is used
Further, has anyone come up with a better and more reliable way for tightening down the rest in place so it doesn't move? If so, I would love to hear what your doing.
Thanks for any help in advance.