I'm using my Nova Cole Jaws for the first time and the plates all set at an angle to the plane of rotation.
The picture describes it best.
The mismatch is just under 1/8", measuring 0.112". The error is very close to the same between any two adjacent jaws.
Should I be concerned or just mount up the bowl and let it sort itself out?
These jaws are cast and not machined. The chuck is an old one and I'm not sure if the problem is the chuck or the Cole jaws.
The picture describes it best.
The mismatch is just under 1/8", measuring 0.112". The error is very close to the same between any two adjacent jaws.
Should I be concerned or just mount up the bowl and let it sort itself out?
These jaws are cast and not machined. The chuck is an old one and I'm not sure if the problem is the chuck or the Cole jaws.