Here's a Murphy's Law thing that happened to me the other day and I pass it on so others may benefit. Put some thin CA into a crack in a chunk of cherry, waited about 20 seconds, shot it all with accelerator, stepped aside and turned on my PM. Zingo! A shot in the left eye, under the glasses I was wearing! A bit of shock and dismay, to say the least. Appartently, the crack was deep enough that the CA was able to avoid being hardened and came shooting out when the lathe was turned on. So, yesterday, I bought a pair of wrap-around bifocals to wear while turning. I don't think anything is going to skip thru or under that pair of glasses. And, if I remember to do so, I will turn down the speed next time before re-starting the lathe! Phil