- Joined
- May 7, 2004
- Messages
- 24
- Likes
- 2
I've seen a simple plan for making a remote switch with a magnetic base. But the plan doesn't say exactly how the switch is wired in. It sounds as if the switch is, in effect, just spliced into the lathe's power cord, so that using the remote switch is equivalent to unplugging the lathe. This plan was specifically proffered for the PM3520. My question is this: Would this sort of remote switching do any harm to the electronics?
On an unrelated note, does anyone know why the knock-out bar for the PM3520 slides in and out of the weighted handle?
Bill
On an unrelated note, does anyone know why the knock-out bar for the PM3520 slides in and out of the weighted handle?
Bill