Right place, wrong cutter. John shows their round cut.Is this what you are looking for?
D Profile - 'W' Cut
This tool tip carves a 'W' texture to provide a triple grooved result.therotarychisel.com
Take a look at the Manpa brand cutters made for rotary tools with a collet. The shaft sizes are 1/8" or 1/4" and you can choose either a round or triangle shaped carbide cutter head that you can remove and resharpen. They are sold in several place and run $60-$65. Try Amazon, Woodcraft, King Arthur Tools, Kilingspor's. Attached is a photo of triangle shaped tool. I am planning on also getting the round headed one soon. It works nicely.Does anyone know ow where to get this tool. The tool I want looks like this but has 3 V shaped cutters but they aren't aligned and vmcut 3 grooves with each pass. Used to be rotarytool.com but that site is no good. They were stone carving tools and used to have a booth at a lot if AAW symposiums. View attachment 62499
Yes, the picture shows the round cutter but in his description he was asking for a similar tool with the “w” cutter.Right place, wrong cutter. John shows their round cut.
My mistake. But I don't know what this means either. "vmcut 3 grooves with each pass"Yes, the picture shows the round cutter but in his description he was asking for a similar tool with the “w” cutter.
Not sure too. I get the meaning.My mistake. But I don't know what this means either. "vmcut 3 grooves with each pass"
Didn't that cutter used to be 3 small notches ground into the 3 wings? Those things got expensive since I looked at them decades ago. LOLNot sure too. I get the meaning.
With the 3 cutters offset it can cut 3 parallel lines.
The outer Osage Orange ball is textured with a bit with 3 off set cutters
Just short strokes with the grain and perpendicular.
View attachment 62516
Yes, please. We'd like to see.We will see.