This is a used Woodcut Bowlsaver original size (two knives). It has cored some bowls but has a lot of life left on the knives. I bought it used and used it on both a 16” and 20” lathes and it worked well. I upgraded to a Oneway so I can get cores larger than 12-13”.
For transparency, the previous owner stated the knives seemed to run low and rubbed hard against the plastic support block at the front and made it hard to move. I noticed this was the case and saw the knives could twist forward in the support. To remedy this I taped in some thin aluminum shims and the system worked well. You can see them in the picture and they could be remove/replaced if desired It’s just aluminum flashing. Other than that and some were on the front plastic support block it is in good shape.
does have manual, depth gauges that I made and Allen wrenches.
$350 shipped in the continental US
For transparency, the previous owner stated the knives seemed to run low and rubbed hard against the plastic support block at the front and made it hard to move. I noticed this was the case and saw the knives could twist forward in the support. To remedy this I taped in some thin aluminum shims and the system worked well. You can see them in the picture and they could be remove/replaced if desired It’s just aluminum flashing. Other than that and some were on the front plastic support block it is in good shape.
does have manual, depth gauges that I made and Allen wrenches.
$350 shipped in the continental US
