• April 2025 Turning Challenge: Turn an Egg! (click here for details)
  • Congratulations to Kelly Shaw winner of the March 2025 Turning Challenge (click here for details)
  • Congratulations to Ellen Starr for "Lotus Temple" being selected as Turning of the Week for 21 April, 2025 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Wolvarine Grinding Jig Platform

Joined
Mar 21, 2006
Messages
76
Likes
0
Location
Vienna, Virginia
The Wolvarine platform has a straight front. For grinding side angles on a scraper this can be done if the tool is about 3/4" wide as it still lays on the platform. However for narrow scrapers like 1/4" the tool is falling off the platform. Has anyone cut out a slot in front of the platform for the wheel so the platform better supports small width scrapers during side grinds?
 
Yes.

Mark the cutout on the platform while at one wheel, then move it to the other to see how well it is going to line up. You may have to widen it up a bit so it fits on both sides.

I also helps out with shorter parting tools and NRS'.
 
Back
Top