I'm having a problem with my shop crane and I need some advice. The arm won't stay up with a load on it. The cylinder is not leaking and I made sure that it was full of oil. This just started. Thanks for the help.
-
January Turning Challenge: Thin-Stemmed Something! (click here for details) -
Conversations are now Direct Messages (click here for details) -
Congratulations to John Lucas for "Lost and Found" being selected as Turning of the Week for January 13, 2025 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Shop Crane
- Thread starter Paul M. Kaplowitz
- Start date
Sounds like your release valve (at the base of the cylinder) is not tightened properly. Open it full and then fully close it. If that doesn't cure, it's likely you got a piston ring seal issue that's letting fluid bypass.
- Joined
- Jan 27, 2005
- Messages
- 13,039
- Likes
- 5,481
- Location
- Dalworthington Gardens, TX
- Website
- pbase.com
Or ... a leaking check valve.