• We just finished a fairly major forum upgrade. If you are having problems using the forums, please clear your browser cache and that should clear up any issues. Otherwise post in the Help Thread or email us at forum_moderator@aawforum.org. Happy Holidays!
  • It's time to cast your vote in the December 2024 Turning Challenge. (click here for details)
  • Congratulations to Vincent Luciani for "Flower Pot" being selected as Turning of the Week for December 23, 2024 (click here for details)
  • Conversations are now Direct Messages (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

My lathe does the 2 step but I can't dance.

K

Kenny

Joined
May 17, 2004
Messages
50
Likes
0
Location
Tulare California
Got a question? Does you Jet 1642 or like model Dance?? I have a Ballest box filled with about 400 lbs of cement. the box is attached to two long boards that rest (without mechanical attachment) to the lathe. I still have a bad problem with dancing a few inches plus when turning slightly out of round at or above 800 rpm. and full out of round at or above 450 rpm. is this just normal- should I bolt the big boy to the floor?
Just curious of your opinion.
 
Bob, that is a great jig. For those without a bandsaw, this is a winner.

Kenny, my 1642 doesn't dance at all. It may shimmy a bit with an oversized, unbalanced piece, but it doesn't move inches. I've only 140 extra lbs on a shelf below the lathe.
rick
 
Last edited:
You must log in or register to reply here.
Back
Top