I've discovered diamond plates come in Super fine, fine, medium, and course. Which grit is best for honing woodturning tools?
-
Congratulations to Alex Bradley winner of the December 2024 Turning Challenge (click here for details) -
Conversations are now Direct Messages (click here for details) -
Congratulations to Gabriel Hoff for "Spalted Beech Round Bottom Box" being selected as Turning of the Week for January 6, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Honing Tools
- Thread starter LANKFORD
- Start date
- Joined
- Jan 27, 2005
- Messages
- 13,037
- Likes
- 5,480
- Location
- Dalworthington Gardens, TX
- Website
- pbase.com
If you are only doing honing, then Fine is probably the preferred grit.
Bill
Bill
I agree with Bill. I find that the super fine is too slow and the medium is too coarse, but the fine is just right. It only takes few seconds to get a good honed edge with the fine.
john lucas
AAW Forum Expert
I use the medium most of the time especially for raising a burr on my scrapers. I use the fine and super fined to put an edge on my skew and usually touch it up with the fine followed by the super fine.