-
Congratulations to Alex Bradley winner of the December 2024 Turning Challenge (click here for details) -
Conversations are now Direct Messages (click here for details) -
Congratulations to Gabriel Hoff for "Spalted Beech Round Bottom Box" being selected as Turning of the Week for January 6, 2024 (click here for details) -
Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
face plates needed!
- Thread starter johannes
- Start date
Walker Turner Lathe
My Walker Turner lathe has a 1 inch 12 tpi spindle on both the inside and outside.
I found aluminum face plates at Lee Valley and Grizzly for this spindle. Those are the colored ones and run about 12 bucks each. 2 inch or 3 inch available.
I have one stainless steel Oneway 4 inch plate. But I can't afford many of those.
Check with the folks at OWWM.com That is Old Woodworking Machines
They have a wealth of knowledge and pointers. The Walker Turner Section has a large number of pictures and original factory catalogues. I recieved the advice I needed to take my lathe apart, rebuild the headstock and feel comfortable knowing what I was doing. Also they helped me to date my 'old arn' to 1936.
John 🙂
My Walker Turner lathe has a 1 inch 12 tpi spindle on both the inside and outside.
I found aluminum face plates at Lee Valley and Grizzly for this spindle. Those are the colored ones and run about 12 bucks each. 2 inch or 3 inch available.
I have one stainless steel Oneway 4 inch plate. But I can't afford many of those.
Check with the folks at OWWM.com That is Old Woodworking Machines
They have a wealth of knowledge and pointers. The Walker Turner Section has a large number of pictures and original factory catalogues. I recieved the advice I needed to take my lathe apart, rebuild the headstock and feel comfortable knowing what I was doing. Also they helped me to date my 'old arn' to 1936.
John 🙂