- Joined
- May 16, 2005
- Messages
- 3,540
- Likes
- 15
With apologies for the poor camera angle, a straight chisel presented at a skewed angle. My setup is not really made for demos, and my videographer isn't really into turning, merely humors me.
http://s35.photobucket.com/albums/d160/GoodOnesGone/?action=view¤t=CylinderRough.flv
Speed, for those who are interested, is my standard 680, wood is cherry, and I would normally stand a bit closer so I could use my body and not just my wrists.
For this type of operation, tool thickness isn't a player. If you were to make beads or V groves, you'd run into clearance problems. What you won't do is feed the nose of the tool into the wood by accident while paying attention to the cutting portion.
What does the nearly round surface look like? http://i35.photobucket.com/albums/d160/GoodOnesGone/Roughed.jpg Pretty much as you see here. A finishing pass made with the edge a bit more vertical would make it shine.
http://s35.photobucket.com/albums/d160/GoodOnesGone/?action=view¤t=CylinderRough.flv
Speed, for those who are interested, is my standard 680, wood is cherry, and I would normally stand a bit closer so I could use my body and not just my wrists.
For this type of operation, tool thickness isn't a player. If you were to make beads or V groves, you'd run into clearance problems. What you won't do is feed the nose of the tool into the wood by accident while paying attention to the cutting portion.
What does the nearly round surface look like? http://i35.photobucket.com/albums/d160/GoodOnesGone/Roughed.jpg Pretty much as you see here. A finishing pass made with the edge a bit more vertical would make it shine.