• November Turning Challenge: Puahala Calabash! (click here for details)
  • Congratulations to Ted Pelfrey for "Forest Floor" being selected as Turning of the Week for November 4, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

3520b

  1. Peter D'Attomo

    Powermatic 3520b wont run

    Went to start it up yestreday and it wont run. I unplugged & replugged, no change. I reset the VFD, & disingaged the on off button( mushroom), unplugged it, heard 2 clicks from the VFD. Replugged it, initiated the on off & speed control, and the lathe ran. I then lowerd the speed control &...
  2. Clifton C

    Powermatic 3520 bed extension

    Looking for "50 inch Bed Extension with Leg for 3520B 6294726B" Or, know of a shipper or warehouse that might have one stashed... Thanks cc
  3. B

    WTB Powermatic or Robust

    My Jet 1440 is in need of an upgrade. I'm looking for a good condition PM 3520B/C or a Robust in the Pacific Northwest. Any leads would be appreciated. Thanks, Bill
  4. J

    Powermatic 3520B VFD Replacement

    About a week ago I had the VFD on my 3520B go out with a puff of smoke. I found two of the capacitors inside had blown. So I purchased and soldered on replacements but the failure also took out the controller board. In researching a replacement as I was not about to spend $600 on a 20 year old...
  5. Rusty Fleeman

    Bent Quill Bolt on a 3520?

    When I run out the quill on my Powermatic lathe, it is as smooth as the day I bought it from about the 3" mark until it unthreads. From 3" down to 0, it gets gradually stiffer to the point it almost takes two hands to turn. I pulled it all apart today, checked for damaged threads, debris, &...
Back
Top