• November Turning Challenge: Puahala Calabash! (click here for details)
  • Congratulations to Paul May for "Staircase Study #1" being selected as Turning of the Week for November 11, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Silver Maple Platter w/ Natural Feet
Michael Anderson

Silver Maple Platter w/ Natural Feet

This is a bigger version of a similar platter I posted to the gallery a while ago. This time, I didn't make the mistake of adding colored dots to the border. For this piece, as with the last one, I wanted to make a platter that was supported by little burl eyes, a la feet. I also wanted to keep as much natural contour as possible, so I turned away the sides with a gentle curve. This gives the illusion that the platter is floating, hence my main photo. I kept the face of the platter relatively simple, with a slightly raised and sharp lip that borders a small and shallow dish. 10"d x 2"h
Keeping the face natural was also a good way to show off the junction between the "normal" brown wood and the gray burl. There are some nice minor spalting zone lines visible as well. One of the coolest reasons to keep the natural edge is to contrast a relatively round face with a totally non-round back. Pretty fun contrast of shapes, imho. Here are a couple of views of the front and the back:

FabBek1.jpeg

DFzA1pk.jpeg
 
Thanks a lot Vincent, Sam, and Will. It does look like the moon. Ha! I hadn't thought of that, but now I can't unsee it :)

Brian, thanks! I made a bunch of shims and superglued them to a piece of plywood. Then I hot-glued the blank to the plywood/shims. I had to plan it out so that the feet (little burl eyes) would give a stable foundation, and so that I had enough material to create a dish and the wide border. I'm almost certain that the planning/mounting process took much longer than the actual turning. Here are a couple of progress shots:
CNRHyfp.jpeg

KHSQdHc.jpeg
 
Most of it did, for sure! I tried to avoid the little crevices on the burl eyes and anywhere else that might be difficult to remove. A little it of denatured alcohol helped the tiny bits that were stubborn.
 

Media information

Category
Member Galleries
Added by
Michael Anderson
Date added
View count
809
Comment count
8
Rating
0.00 star(s) 0 ratings

Image metadata

Device
SONY ILCE-7M2
Exposure time
1/13 second(s)
ISO
2000
Flash
Off, did not fire
Filename
_DSC5947.jpg
File size
805.5 KB
Date taken
Mon, 24 April 2023 12:52 PM
Dimensions
1800px x 1200px

Share this media

Back
Top