• November Turning Challenge: Puahala Calabash! (click here for details)
  • Congratulations to Ted Pelfrey for "Forest Floor" being selected as Turning of the Week for November 4, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Spalted Maple Hollow Form
Spalted maple platter
Norway maple footed bowl
Spalted Pacific crabapple (Malus fusca)
Spalted Maple Hollow Form
Walnut Vase #481
Transition
Maple box
Nino G. Cocchiarella

Spalted Maple Hollow Form

Another piece of wood that was on the edge. Some very soft and some very hard sections on this one. Turned long grain 10x4" and too thin on the bottom half. Can see light through it along the bottom! The top is around 3/16". I have been leaving around 1/2" thick at the base for stability.

Any thoughts, advice or forum threads about turning wood with very soft and very hard parts of a blank? The contrast is challenging.
Click to expand...
  • Like
Reactions: Ed Davidson, Randy Anderson, Ric Williams and 19 others
Charlie Knighton
Imo maple is prone to that after it sits, #1 suggestion chose a different wood, mesquite comes to mind, sort of solves all ur problems
 
Randy Anderson
Nino, on the big maple vase I just finished I had similar challenges. Since the coloring is so varied I used a good bit of thin CA on areas to stiffen the fibers to get a clean cut. If you manage the application to just little to where needed, take a cut and stop or repeat if needed you can get clean cuts and not create a lot of obvious CA glue trails. Some might show but they blend in and you'll be the only one that knows it's where you put CA and not just where the wood tone changes.
 
Nino G. Cocchiarella
Randy Anderson said:
Nino, on the big maple vase I just finished I had similar challenges. Since the coloring is so varied I used a good bit of thin CA on areas to stiffen the fibers to get a clean cut. If you manage the application to just little to where needed, take a cut and stop or repeat if needed you can get clean cuts and not create a lot of obvious CA glue trails. Some might show but they blend in and you'll be the only one that knows it's where you put CA and not just where the wood tone changes.
Click to expand...
Randy, I saw that vase. Very nice. I’ll give the CA glue a try next time.
 

Media information

Category
Member Galleries
Added by
Nino G. Cocchiarella
Date added
View count
417
Comment count
3
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
IMG_3977.jpg
File size
478.7 KB
Dimensions
1512px x 1816px

Share this media

Back
Top