• November Turning Challenge: Puahala Calabash! (click here for details)
  • Congratulations to Ted Pelfrey for "Forest Floor" being selected as Turning of the Week for November 4, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.
Vortex Bowl
Breast Cancer Memorial urn
Legendary Kracken Brothers
Brass Patches 2
Vortex Bowl
Suger Maple Burl Vessel detail
Sugar Maple Burl Vessel
Serial 21058 Detail
GRJensen

Vortex Bowl

My first attempt at a vortex segmented turning. Bowl is 8” in diameter and about 2-1/4” deep. Segments are black walnut and hard maple, finish is 5 coats of wipe-on poly.

The blank was a spiral disk, comprised of segments cut on the bandsaw, then parted into rings that are stacked and turned. The design, and the jig used to cut the segments, were inspired by Gary Asher, ThePapa1947 on Youtube ( https://youtu.be/sodQISh5DDs ).
Click to expand...
  • Like
Reactions: Roger Chandler, Tom Lohman, Gerald Lawrence and 6 others
Don Wattenhofer
The biggest problem with any segmented piece where the sharpe points meet in the middle is the difficulty of getting the alignment perfect but you to have exceeded that of the videos you referenced.
That is a major accomplishment.
 

Media information

Category
Member Galleries
Added by
GRJensen
Date added
View count
1,305
Comment count
3
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX L830
Aperture
ƒ/3.4
Focal length
6.8 mm
Exposure time
1/125 second(s)
ISO
125
Flash
Off, did not fire
Filename
Spiral-01.jpg
File size
1.3 MB
Date taken
Fri, 23 July 2021 1:04 PM
Dimensions
2588px x 2641px

Share this media

Back
Top