1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. The forum migration is complete. We had some issues with the hosting provider and I had to restore the server a 2nd time so if you happened to post from about 9:30pm - 11pm PST your post may have been removed. Please double check to see if its still there. If you have any issues post them in the technical support forum or email the AAW Forum Staff at forum_moderator@aawforum.org. Thanks!
    Dismiss Notice
  3. Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

S Curve Tool Rest

Discussion in 'Marketplace Archives' started by Tom Albrecht, Oct 6, 2019.

Thread Status:
Not open for further replies.
  1. Tom Albrecht

    Tom Albrecht

    Joined:
    Feb 8, 2014
    Messages:
    810
    Location (City & State):
    Evanston, IL USA
    Cast Iron S Curve Tool Rest with 1" X 6" Post

    As described on Craft Supplies USA:


    Details
    The specially designed Apprentice™ S-Curve Tool Rest is an excellent tool for reaching into deep bowls. The two shaft mounting holes allow the bowl rest to reach along the outside of the bowl, or 6-1/2" inches into the bowl. The two extra inches of reach beyond the standard tool rest allows greater tool control inside deep bowls. It will work well with gouges or scrapers with the tool supported close to the work, reducing tool catches and producing superior results. It is designed for inboard turning. Bowl rest is 2" thick.

    Has seen very little use. New at Craft Supplies the cost is $70 plus shipping.

    I will take $55 including shipping in USA.



    tool rest - 2.jpg tool rest - 1.jpg tool rest - 3.jpg
     
    Last edited: Oct 6, 2019
Thread Status:
Not open for further replies.

Share This Page