1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. ATTENTION FORUM MEMBERS!

    Guest, if you have not yet updated your forum bookmark to a secure log in connection, please delete your unsecure book and add the following secure bookmark: https://www.aawforum.org/community/index.php

    You can dismiss this notice by clicking the X in the upper right of the notice box.

    Dismiss Notice

Kobra Hollowing system

Discussion in 'Marketplace Archives' started by Marty Purselley, Aug 12, 2020.

Thread Status:
Not open for further replies.
  1. Marty Purselley

    Marty Purselley

    Joined:
    Nov 1, 2008
    Messages:
    35
    Location (City & State):
    Aledo, Texas
    Consolidating thread-please close.
     

    Attached Files:

    Last edited: Aug 14, 2020
  2. Jerry Lear

    Jerry Lear

    Joined:
    May 4, 2012
    Messages:
    23
    Location (City & State):
    Baldwin, Maeyland
    would this work on Robust AB
     
  3. Marty Purselley

    Marty Purselley

    Joined:
    Nov 1, 2008
    Messages:
    35
    Location (City & State):
    Aledo, Texas
    Not sure. I think it would depend on the lathe ways measurement. This one has a base plate specifically for the 4224.
     
  4. Marty Purselley

    Marty Purselley

    Joined:
    Nov 1, 2008
    Messages:
    35
    Location (City & State):
    Aledo, Texas
    Moderator-please CLOSE this thread as I will be posting a consolidated thread representing the liquidating of my shop.
     
    Emiliano Achaval likes this.
Thread Status:
Not open for further replies.

Share This Page