• Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Paul May for "Checkerboard (ver 3.0)" being selected as Turning of the Week for March 25, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Gast V113A-AE Vacuum pump, $100

Status
Not open for further replies.

Roger Wiegand

Beta Tester
Joined
Nov 27, 2018
Messages
789
Likes
914
Location
Wayland, MA
Website
www.carouselorgan.com
This pump came with an unused, brand new vacuum bagging setup found at an estate sale. As far as I know it has never been used. I had hoped to use it for a vacuum chuck as well as the veneering setup and a vacuum pot, but the flow rate is not sufficient for that (about 0.5 cfm). It would be fine for any sealed system, such as a vacuum pot for resin infusion. I bought a higher flow rate pump to operate my vacuum chuck, so this one is not needed. I've turned it on to see that it works, but not connected it to anything (it went to about 27" with my finger over the inlet)

$100 plus actual shipping from 01778.

62E88AA7-3CC3-4F48-8F67-525A9F501793_heic-L.jpg


36A7109D-B526-49BA-8D40-3CDB6A7A6EBF_heic-L.jpg


11329504-2AD8-4E4F-9152-ECDAF8CE3F11_heic-L.jpg
 
Status
Not open for further replies.
Back
Top