Hello, I recently turned a White Oak Burl bowl. It was from a piece of burl that had been sliced at a band saw mill.
It is about 10 X 4. It came out quite nice. I brought it in the house to show my wife. It sat on the dining room table
for at least a week. Now I have a little rocking as it has moved a little. My question is could I remount it on the lathe?
I used the Oneway super jumbo jaws to do the bottom. Am I asking for trouble by going back to the lathe. I have
enough thickness. This piece of wood had been sitting in my barn for about 3 years Thanks in advance, Kevin
It is about 10 X 4. It came out quite nice. I brought it in the house to show my wife. It sat on the dining room table
for at least a week. Now I have a little rocking as it has moved a little. My question is could I remount it on the lathe?
I used the Oneway super jumbo jaws to do the bottom. Am I asking for trouble by going back to the lathe. I have
enough thickness. This piece of wood had been sitting in my barn for about 3 years Thanks in advance, Kevin