• We just finished moving the forums to a new hosting server. It looks like everything is functioning correctly but if you find a problem please report it in the Forum Technical Support Forum (click here) or email us at forum_moderator AT aawforum.org. Thanks!
  • Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Dave Roberts for "2 Hats" being selected as Turning of the Week for April 22, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Baxter's Threadmaster for Vicmarc VL 100 (10 inch swing) Colorado Springs, Co

Status
Not open for further replies.
D

Dr. Bob

Joined
Apr 6, 2007
Messages
12
Likes
0
I'm selling this for the widow of a club member. It's never been used. The Best Tools site lists it at $ 500 and it also has two 2 inch face plates listed at $ 60 so a value of $ 560 if my math is correct. The Best Tools site also says it is for lathes with a 9" to 12 1/2" swings with the right height riser. This one has the 10" one for the VL 100 or the Jet 1014. The cutter is TC 75, 3/4 inch.

Asking $ 400 plus shipping (it should fit into a large flat rate USPS box $ 21 or so).
(Or available for pick up in Monument, Colorado)

Robert Gibbs
E mail bobandcamilla@comcast.net
Home phone 719 488 9487Baxter's Threadmaster.jpeg
 
Status
Not open for further replies.
Back
Top