1. Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

Baxter's Threadmaster for Vicmarc VL 100 (10 inch swing) Colorado Springs, Co

Discussion in 'Marketplace Archives' started by Dr. Bob, Nov 11, 2020.

Thread Status:
Not open for further replies.
  1. Dr. Bob

    Dr. Bob

    Joined:
    Apr 6, 2007
    Messages:
    11
    I'm selling this for the widow of a club member. It's never been used. The Best Tools site lists it at $ 500 and it also has two 2 inch face plates listed at $ 60 so a value of $ 560 if my math is correct. The Best Tools site also says it is for lathes with a 9" to 12 1/2" swings with the right height riser. This one has the 10" one for the VL 100 or the Jet 1014. The cutter is TC 75, 3/4 inch.

    Asking $ 400 plus shipping (it should fit into a large flat rate USPS box $ 21 or so).
    (Or available for pick up in Monument, Colorado)

    Robert Gibbs
    E mail bobandcamilla@comcast.net
    Home phone 719 488 9487 Baxter's Threadmaster.jpeg
     
  2. Dr. Bob

    Dr. Bob

    Joined:
    Apr 6, 2007
    Messages:
    11
    Price reduced to $ 350..........
     
  3. Dr. Bob

    Dr. Bob

    Joined:
    Apr 6, 2007
    Messages:
    11
    Sold........
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice