• We just finished moving the forums to a new hosting server. It looks like everything is functioning correctly but if you find a problem please report it in the Forum Technical Support Forum (click here) or email us at forum_moderator AT aawforum.org. Thanks!
  • Beware of Counterfeit Woodturning Tools (click here for details)
  • Johnathan Silwones is starting a new AAW chapter, Southern Alleghenies Woodturners, in Johnstown, PA. (click here for details)
  • Congratulations to Dave Roberts for "2 Hats" being selected as Turning of the Week for April 22, 2024 (click here for details)
  • Welcome new registering member. Your username must be your real First and Last name (for example: John Doe). "Screen names" and "handles" are not allowed and your registration will be deleted if you don't use your real name. Also, do not use all caps nor all lower case.

roughing gouge

  1. John Torchick

    Advice on drive center and usage

    I have two drive centers that I have from my new lathe and my old lathe. These are the usual ones with the four spurs and the point in the center. I just finished turning to round a piece of cherry as practice with the skew and the roughing gouge. I'm a bit leery about taking a tool too close to...
  2. John Torchick

    Sharpening problem

    I have a set of HF beginner's HSS tools, Rikon low speed grinder, and the Wolverine sharpening jig. My grandson and I were working on a mini baseball bat for his older cousin. While sharpening the 3/4 inch roughing gouge, I held it up to the light and I noticed that one side of the grind was...
Back
Top