I need to turn some 3/4" diameter sphere's out of pine for a rocket project. Any tips?
I was wondering if I should make a turning tool out of a piece of flat bar, drill a 3/4" hole through it, then chamfer the hole, and cut the hole in half. Seems like I could turn the sphere, get it close and then finish it with the custom tool. That might make finishing them to the same size easier?
Thanks in advance for any tips or suggestions.
John
I was wondering if I should make a turning tool out of a piece of flat bar, drill a 3/4" hole through it, then chamfer the hole, and cut the hole in half. Seems like I could turn the sphere, get it close and then finish it with the custom tool. That might make finishing them to the same size easier?
Thanks in advance for any tips or suggestions.
John
Attachments
Last edited: