Hi, I turned this platter out of pecan. I roughed it down and let it sit for a good 4 months. It was a fun project and I didn't even bleed. However, after about 3 or 4 days it now resembled a taco shell than a platter. I mean it's not that bad but there's probably at least a quarter inch of travel when you push on one side or the other. I have not applied finish yet, not sure if that would have saved it. It's about 18-20 inches diameter.
Does anyone think it can be saved? Maybe steam and a cinder block? But then would it just bend again?
Thanks for your thoughts
Raif.
Does anyone think it can be saved? Maybe steam and a cinder block? But then would it just bend again?
Thanks for your thoughts
Raif.